Testing requirements for fabric pilling properties in the national standard

The pilling performance of fabrics is the phenomenon of pilling and pilling that we usually see when using textiles and garments. This kind of phenomenon is very common in daily life, and it is also a problem that textile enterprises have been trying to avoid. The performance testing is not only concerned by textile enterprises, but also has clear standard requirements for textile testing departments in various countries. This article will focus on the testing requirements for fabric pilling performance in the national standard. 1. Reference standard: GB/T 4802.4 Determination of the pilling and pilling properties of fabrics Part 4: Random tumbling method There are four methods to test the pilling performance of fabrics, including the alpha method, the pilling box method and the random tumbling method. 2. Test instrument: random tumbling pilling tester 3. Test principle: put the sample into the test box Under the action of the rotation of the storage box, the cork lining wall of the storage box is continuously and randomly rubbed, and after the set time is reached, the sample is taken out for rating. Fourth, the main instruments and appliances: 1. Pilling box 2. Cork cylinder liner: length 452mm, width 146mm, thickness 1.5mm. Cork pad needs to be replaced after 1 hour of use. 3. Air compression device: make the test chamber reach a certain pressure (14-21KPa). 4. Adhesive, gray short cotton. 5. Rating box: use white fluorescent Tube or bulb illumination. The position of the light source is kept with the specimen plane 5°—15°, the observation direction is kept 90° from the sample plane°±10°. The distance between the eye with normal vision and the specimen should be 30cm—50cm. V. Preparation of samples: 1. Pretreatment: If pretreatment is required, the samples can be washed or dry cleaned by the method agreed by both parties. 2. Take 3 samples from the fabric sample, the size is (105±2) mm*(105±2) mm, and cut another cloth sample of the same size as a comparison sample for rating. The specimens were marked and the edges of the specimens were sealed with adhesive and hung to dry. 6. Test steps: 1. Put 3 samples from the same sample into different test chambers for testing. 2. Put the gray cotton wool together with the sample into the test chamber (weight 25mg, length 6mm) 3. Set the test time to 30min, start the instrument, and open the airflow valve. 4. After the test, take samples for rating, and use a vacuum cleaner to remove the remaining cotton wool. 7. Rating of test results: The rating box should be placed in a dark room. Place the tested sample and an untested sample side by side in the middle of the test panel of the rating box in the longitudinal direction of the fabric (if the test sample is pre-treated before testing, the control sample should also be pre-treated. pretreatment, the reference sample shall be the unpretreated sample). Put the tested sample on the left and the untested sample on the right. Ratings are subjective and at least 2 ratings are recommended. The appearance of the samples and the corresponding grades are as follows: record the grades of each sample, and the rating result of a single person is the average value of the grades for all the samples. The test result of the sample is the average value of the ratings of all personnel. If the average value is not an integer, it should be corrected to the nearest 0.5 level and used“—”means, such as 3—4. If a single test result differs from the average by more than half a class, the class number for each specimen shall be reported at the same time. More about Fabric Pilling Tester: http://www.standard-groups.com/TextileGarment/

GESTER International Co.,Limited is trying to institute social good changes this relationship because it averts a firm's resources from its core task of increasing profits.

Try out tensile tester manufacturers textile testing equipment to beautify your tensile tester manufacturers. Visit GESTER Instruments to get your dreaming at a favorable price.

To stay in contact for latest review of textile testing equipment tensile tester manufacturers across the globe and find out quality products, just go to GESTER Instruments.

GESTER International Co.,Limited offers the best for indoor as well as outdoor use. To find your ideal at attractive offers, visit us at GESTER Instruments.