Standard Encyclopedia: European Standard Washing Machine Standards, Operation Process

Compliant with standards: 　　ISO 5077/6330 Mu0026S P1/P1A/P3A /P12/P91/P99/P99A/P134　　BS EN 25077/26330 IWSTM 31 IEC 456 NEXT TM 7/7A/7B/12　　Application area: 　　 European standard Wascator FOM 71 The shrinkage tester is a European standard shrinkage tester, which has long been a reference for textile laboratory standards. It is used to test the shrinkage and appearance of the fabric after washing, and it fully meets the requirements of European standards and the testing requirements of retailers.　　Using method and precautions: 　　Before use: sort the fabric, check whether the liner is empty, add the fabric, close the door, check the emergency stop button, and keep it in an unpressed state. 1. There are three ways to start the washing program: enter the known program number and press the Select button; when you are not sure which program is available, you can select an existing program from the program library. The specific description of the program is in the program list. Display; select an existing control program from the memory card.　　 2. If you need to change the parameter, press the up and down movement keys to the parameter you want to modify, press the select key, use the numeric keys to input the new parameter, and press the select key.　　 3. Fast forward: used to end a program early. Select rapid advance, press select key, select end of program, press select key, when 'door open' is displayed on the screen, you can open the door.　　4. During the program running, you can view the real-time load and water level on the display by selecting it. You can also use the pause, manual function selection, new washing program selection, text input, temperature unit change, automatic restart and other functions.　　5. Data statistics 　　Data statistics function can see information including: total running time, running time of this operation, the last 5 error codes, and the number of used programs. Common problems and solutions: common problem solutions. After the no water and no water prompt appears, reset the setting, the washing machine will automatically retry after the door open prompt appears, reset the setting, the machine will automatically retry the temperature is too low/high temperature is below/ It is higher than the allowable minimum/maximum value, check the temperature sensor overload. Pay attention to the machine load not heating. Check the 'min. temperature increase' and 'max. heating time' options in the settings, restart the washing machine level adjustment to check the washing machine's level status, Perform horizontal calibration. Communication interruption program. The communication between the module and the system is interrupted. Press the start button to restart the washing machine. The motor is overheated. Check whether the motor is overloaded, whether the vent is blocked, and whether the ambient temperature is too high.

Look at the trends, both economic and consumer, for indications on your GESTER International Co.,Limited's staying power.

To discover more about the tensile tester manufacturers benefits of , go to GESTER Instruments.

With the help of a tensile tester manufacturers textile testing equipment, tensile tester manufacturers becomes a reasonably easy job that you can take care of simply and swiftly.